REPLACING e30 (NON-ABS Drum brake Model) CV Rubber Boots (Left Hand side).
Undo 30 mm Nut
Drop Exhaust by releasing rear box clamps (X2).
and the fwd hanger mount (13mm Bolt)
Undo the Bolts (X6) on the inner CV Joint (I used a TORX T50 But an appropriate allenkey will be a better fit) and drop the axle by pushing it outwards and let it drop and use a copper-drift to get the axle out of the hub
Get the inner dustcover off with a screwdriver, remove the small circlip at the end of the shaft and all the boot retaining clips and remove the CV Joint by sliding it off.
The outer boot just pulls off after releasing the Clips (Sorry No Photos as my Hands were covered in grease and could not get the phone to work ).
Rinse out both joints with brake cleaner and refitting is the reverse but making sure you use new grease on both CV joints (Came in the kit).