So, as I fit my Dave F induction kit I'm going to show you the process.
Flat blade screw driver
Make sure you have everything pictured below
First up, remove the old airbox by uncliping the clips im pointing to at the MAF.
now unbolts these 2 x 8mm nuts
Give the airbox a wiggle and pull it up out of the engine bay
I Cleaned around the above area quickly before fitting my kit.
Now fit the shield, pretty self explanatory really. You need 2 nuts and one bolt to secure it into place.
Fit the rubber hose section over the MAF
Next the Induction pipe, through the hole in the shield in the rubber hose
Finally the filter
Check over your work make sure everything is tight and leave no tools in the engine bay!
Hope this helps the newcomers.