I'm after some advice please.
I've changed my crankshaft pulley and tightened to 100Nm by putting a screwdriver into the bottom access hole. I'm now trying to do the extra 60' 60' 30' but would like some direction on a more solid means of locking the flywheel?
I've taken the rubber bung off to look inside but the plate that houses the bung looks like aluminium and therefore very flimsy.
I've noticed that there looks like a 10mm diameter hole on the flywheel but have no idea how to access it safely.
Is there a tool that isn't going to cost the earth or do i get someone to get underneath and try to hold the large screwdriver in?
Any advice of pointers greatly appreciated.