Some of you are I am sure aware that I have recently a 2007 E86 Z4 3.0Si which had a little problem with the passengers side window struggling on opening that I knew about when I purchased it - anyway recently I have replaced the regulator cables as per the instructional videos I found on Youtube
and also performed the reset procedure within this forum
Wind noise from either window, despite doing a window reset? - Z4-forum.com but now I have a little problem - When I open the door it doesn't drop the 5mm that it used to, but if I push it down manually it will roll back up 5mm when I close the door.
The window now seems to function perfectly well other than this, single touch up and down and a nice smooth operation (with no horrible grinding sounds or stalling from the motor, I just have to remember to push it down before I try to close the door.
I suspect that this is a set-up issue or adjustment procedure that I have not performed correctly, but I welcome any help or advise that anyone has to offer. Has anybody had a similar issue with a frameless window and what was the resolution?
The cables only cost £18.... A new regulator is nearer £200, but not sure how this would help anyway as the regulator is the bit that now works.. Thanks in advance.